User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
Troubleshooting 89
Troubleshooting
The following topics are covered in this section:
■ when your radio won’t turn on
■ removing the microphone
■ reinstalling the microphone
■ removing the radio from the vehicle
■ describing the radio’s audible tones
When your radio won’t turn on
If the red, green and amber LEDs on the control head do not
light up when the radio is turned on, it is likely that no power
is reaching the radio. Check the following:
■ Is the power connector firmly plugged into the rear of
the radio?
■ Are the in-line fuses in good condition?
■ Is the power cable securely connected to the vehicle bat-
tery or power supply?
If all appears to be in order, then contact your radio provider
for further assistance.
Removing the microphone
1
Using your thumb or forefinger, lift up one
of the corners of the microphone grom-
met. Firmly (but gently) pull that corner
until the seal comes away from the cavity.
2 Repeat to expose another corner.
3 Pull the exposed corners back and slide the grommet up
the microphone cable to reveal the microphone plug.
4 Remove the plug from the microphone socket.
grommet