User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
76 Operating in MPT trunked mode
Changing your call queuing setting
Your radio may be programmed so that you are able to
change call queuing to “unanswered”. Unanswered call
queuing means that all status and text messages are
immediately queued. Incoming voice calls are only queued if
they are unanswered. An unanswered call is one that is
ended by the radio making the call before the radio receiving
the call has responded in any way.
If your radio has alphanumeric keys, you may be able to
change your call queuing setting using the keypad.
To activate call queuing:
■ select Menu>Radio settings>Call settings>Call queuing
and choose On, or
■ dial *48 then press the or PTT key.
The message Call queuing activated appears.
To change call queuing to unanswered call queuing:
■ select Menu>Radio settings>Call settings>Call queuing
and choose Off, or
■ dial #48 then press the or PTT key.
The message Call queuing deactivated appears.