User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
66 Operating in MPT trunked mode
Changing group membership
There are two methods of changing your membership of
talkgroups or scan groups. You may be able to either:
■ use you Quick Access menu to join a single talkgroup or
scan group, or
■ use the Main menu to change your membership of
multiple groups.
Selecting a new group using your Quick
Access menu
You may be able to use your Quick Access menu to select a
new talkgroup or scan group. Selecting a new group means
that the previously selected group is automatically deselected.
To select a talkgroup or scan group:
1 Press the left selection key
to enter the Groups menu.
The currently selected talkgroup
or scan group has + beside it.
2 Scroll through the list of groups,
until the talkgroup or scan group
you want to select appears.
3 Press Join or wait for three
seconds.
The previous group is deselected
and the new talkgroup ID may
appear in the display.
To make a call to the talkgroup shown, you may be able
to briefly press the PTT key.
Note: It is not possible to make a call to a scan group, but
you can call any of its constituent groups.
Talkgroup
994
Talkgrp Menu
234
Groups
992
Scan1 +
Back Join
Talkgroup
992
Talkgrp Menu
234