User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
Operating in MPT trunked mode 57
Operating in MPT trunked mode
Note: Your radio must have trunking functionality
programmed before it can operate in MPT
trunked mode.
The following topics are covered in this section:
■ changing your operating mode
■ checking that your network is available
■ changing your network
■ making a preset call
■ about talkgroups and scan groups
■ making an emergency call
■ dialling a PABX number
■ dialling a PSTN number
■ receiving a call
■ re-establishing a call
■ checking missed calls
■ about status messages
■ about text messages
■ calls to conventional channels or groups
Changing your operating mode
The way your radio performs basic functions, such as sending
and receiving calls, depends on the operating mode of your
network. The two operating modes that may be available on
your radio are conventional mode (see “Operating in
conventional mode” on page 41), and MPT trunked mode.
To change your radio’s operating mode, you may be able
to either:
■ use a programmed function key, or
■ use the Main menu.