User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
4
Copyright and trademarks
All information contained in this document is the property of
Tait Electronics Limited. All rights reserved. This document
may not, in whole or in part, be copied, photocopied,
reproduced, translated, stored, or reduced to any electronic
medium or machine-readable form, without prior written
permission from Tait Electronics Limited.
The word TAIT and the TAIT logo are trademarks of Tait
Electronics Limited.
All trade names referenced are the service mark, trademark
or registered trademark of the respective manufacturers.
Disclaimer
There are no warranties extended or granted by this
document. Tait Electronics Limited accepts no responsibility
for damage arising from use of the information contained in
the document or of the equipment and software it describes.
It is the responsibility of the user to ensure that use of such
information, equipment and software complies with the
laws, rules and regulations of the applicable jurisdictions.
Enquiries and comments
If you have any enquiries regarding this document, or any
comments, suggestions and notifications of errors, please
contact Technical Support.
Updates of manual and equipment
In the interests of improving the performance, reliability or
servicing of the equipment, Tait Electronics Limited reserves
the right to update the equipment or this document or both
without prior notice.