User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
Basic operation 33
■ a short key press turns backlighting on momentarily, and
■ a long key press turns backlighting on, and it remains on
until there is a further long key press.
Turning backlighting on and off by using a
function key
The function key programmed for Backlighting turns
backlighting on and off. When backlighting is turned on, it
remains on until the function key is pressed again.
Turning backlighting on and off by using the
Main menu
When backlighting is turned on using the menu, it remains on
until the setting is changed to off, regardless of radio activity.
1 Select Menu>Radio settings>
Display settings>Backlighting.
2 In the Backlighting menu,
choose either On or Off.
3 Press Select.
Changing the level of control-head backlighting
The radio’s display and keypad light up when backlighting is
on. This normally only happens when a key is pressed or a
call is received.
You may be able to change the level of control-head
backlighting using the Main menu.
Display settings
Backlight level 2
Backlighting
Back Select
Backlighting
Off 2
On
Back Select