User's Manual

14 TM9100 (40W/50W) Installation Guide

Removing the Control Head Important During this procedure, take care that the control-head seal

is not damaged. Damage to this seal reduces environmental

protection.

1. On the underside of the radio, two lever points are indicated on the

radio body by a dot-dash-dot pattern ( ). The lever point is

between the control-head seal and the control head.

Important When inserting the screwdriver, take care not to damage

the control-head seal.

2. At either of the lever points, insert a 3/16 inch (5mm) flat-bladed

screwdriver between the control head and the control-head seal.

3. Use the screwdriver to lift the control head off the clip, then repeat in

the other position. The control head can now be removed.

Figure 2.2 Disconnecting the control head from the radio body

lever point

indication of

lever point

control-head

seal