User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- Your radio’s settings
- Part 1: Radio operation
- Safety and compliance warnings
- Radio frequency exposure information
- Radio frequency emissions limits in the USA
- Health, safety and electromagnetic compatibility inEurope
- Electromagnetic compatibility in European vehicles
- EN60950 requirements (25 watt radios)
- Safe radio operation
- High radio surface temperatures
- Radio protection when changing the vehicle battery
- Getting started
- Basic operation
- Operating in conventional mode
- Troubleshooting
- Notes
- Safety and compliance warnings
- Part 2: Radio installation procedures
Radio Installation 53
Mounting the U-bracket
The U-bracket can be used to install the radio on the dash-
board or on any sufficiently flat surface, using the self-drilling
screws and washers provided in the installation kit.
Caution: When mounting the radio, check whether the
mounting surface needs to be reinforced.
Caution: The U-bracket must be installed using at least
four screws.
1 If the U-bracket is being mounted over a curved surface,
bend the U-bracket tabs slightly, to match the
surface shape.
2 Drill any holes required for cables and install suitable
grommets or bushings in the holes.
Caution: Check that the U-bracket is not distorted when the
screws are tightened.
3 Screw the U-bracket in the
chosen mounting position using
the self-drilling screws and
washers provided.
Tip: For more precise
positioning, predrill
3 mm (1/8 inch) pilot holes for
the self-drilling screws. Reduce the hole size in metal that
is less than 1mm (1/32 inch) thick.