User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- Your radio’s settings
- Part 1: Radio operation
- Safety and compliance warnings
- Radio frequency exposure information
- Radio frequency emissions limits in the USA
- Health, safety and electromagnetic compatibility inEurope
- Electromagnetic compatibility in European vehicles
- EN60950 requirements (25 watt radios)
- Safe radio operation
- High radio surface temperatures
- Radio protection when changing the vehicle battery
- Getting started
- Basic operation
- Operating in conventional mode
- Troubleshooting
- Notes
- Safety and compliance warnings
- Part 2: Radio installation procedures
Operating in conventional mode 29
Note: Your radio may be programmed to activate monitor
whenever the microphone is off the microphone clip.
To activate monitor, you may be able to either:
■ remove the microphone from the microphone clip,
■ use a programmed function key, or
■ use the Main menu.
Activating monitor by using a function key
1 Press the monitor function key to activate monitor and
hear any traffic on the channel.
While monitor is on, the green
LED flashes continually and the
monitor icon appears in
the icon bar.
2 Press the monitor function key again to turn monitor off,
or wait for monitor to turn off automatically, after a
programmed delay.
When monitor turns off, the
green LED stops flashing and
the monitor icon disappears
from the icon bar.
Activating monitor by using the Main menu
1 Select Menu>Radio Settings>
Function Settings>Monitor.
2 In the Monitor menu,
choose On.