User's Manual

Radio Installation 35

body. The numbers in the diagram on the previous page

refer to the numbered steps below.

1. Plug the control head loom onto the control

head connector.

2. Insert the bottom edge of the control head onto the

two clips in the front of the radio chassis, then snap

into place.

Removing the control head

Important: During this procedure, take care that the

chassis seal is not damaged. Damage to this seal

reduces environmental protection.

1. On the underside of the radio, insert a flat-bladed screw-

driver between the control head and the radio chassis

seal, in either position or .

Note: Insertion points and are indicated

on the radio chassis by a dot-dash-dot

pattern (•

–

•).

2. Use the screwdriver to lift the control head off the chassis

clip, then repeat in the other position.

The control head can now be removed from the radio body.