User's Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Working with Base Stations from Your PC
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- 8 Replacing Modules
- Appendix A – Interface Pin Allocations
- Appendix B – Inter-Module Connections
- Glossary
- Tait Software License Agreement
- Directive 1999/5/EC Declaration of Conformity
DRAFT 1
TB9300 Installation and Operation Manual Replacing Modules 99
© Tait Limited May 2013
8.3 Replacing a Reciter
Removal 1. If you have not already done so, carry out the instructions in “Pre-
liminary Disassembly” on page 97.
2. At the rear of the reciter, unplug the RF input cable
b, any system
cables
c, and the external reference d and 1PPS e cables (if
fitted).
3. At the front of the reciter, unplug the RF output cable
f, and move
it to one side. Unplug both ends of the system control bus cable
g
and remove it.
4. Loosen the screw securing the retaining clamp
h and rotate the
clamp through 90° to clear the module.
5. Slide the reciter out of the subrack, taking care not to damage any of
the cables.
b
c
d
e
f
g
h