User's Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Working with Base Stations from Your PC
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- 8 Replacing Modules
- Appendix A – Interface Pin Allocations
- Appendix B – Inter-Module Connections
- Glossary
- Tait Software License Agreement
- Directive 1999/5/EC Declaration of Conformity
DRAFT 1
82 Installation TB9300 Installation and Operation Manual
© Tait Limited May 2013
5.6 Connecting Up the Base Station
This section provides information relevant to the task of connecting up the
various inputs and outputs of the base station.
5.6.1 Connection Overview
The connections at the rear of a dual 50W base station are identified in
Figure 5.8. External connections are all located at the rear of the subrack.
Figure 5.8 50W base station inputs and outputs
b serial RS-232 connector
a
h +VDC input
c 1PPS input i auxiliary DC output
d external reference frequency input j AC mains input
e RF input 1) Ethernet interface connector
f RF output 1! subrack ground connector
g –VDC input 1@ system interface connector
a. Factory use only.
PA 1
Reciter 1 PMU
bcd
e
f
gh
ij1)1!
1@
PA 2
Reciter 2