User's Manual

DRAFT 1
34 General Safety and Regulatory Information TB9300 Installation and Operation Manual
© Tait Limited May 2013
2.4 Regulatory Information
2.4.1 Compliance Standards
Where applicable, this equipment has been tested and approved to the
following standards.
2.4.2 FCC Compliance
This equipment complies with:
■ CFR Title 47 Part 15 Class B (except PMU):
Radiated and conducted emissions, and electromagnetic susceptibility
specifications of the Federal Communications Commission (FCC) rules
for the United States.
Operation is subject to the following two conditions:
a. This device may not cause harmful interference, and
b. This device must accept any interference received, including
interference that may cause undesired operation.
■ CFR Title 47 Part 15 Class A (PMU only):
Radiated and conducted emissions, and electromagnetic susceptibility
specifications of the Federal Communications Commission (FCC) rules
for the United States.
Operation is subject to the following two conditions:
a. This device may not cause harmful interference, and
b. This device must accept any interference received, including
interference that may cause undesired operation.
RF - B3 Band CFR Title 47 Parts 15, 22, 74 and 90
EN 300 113-1
EN 300 113-2
AS/NZS 4768 Appendix A
RSS-119
RF - K Band CFR Title 47 Parts 15 and 90
EMC ETSI EN 301 489-5
CFR Title 47 Part 15
Safety EN 60950-1
UL E223047 (PMU only)
AS/NZS 60950-1 Q090114 (PMU only)
Environmental
Low Pressure (Altitude)
a
Humidity
Vibration
Shock
a. 15000 ft (4572 m).
MIL-STD-810G Method 500.5 Procedure 2
to be confirmed
MIL-STD-810G Method 514.6 Procedure 1
MIL-STD-810G Method 516.6 Procedure 1
The TB9300 has not passed
the humidity test yet. Do we
put “to be confirmed”, or
just leave that spec out?
?