User's Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Working with Base Stations from Your PC
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- 8 Replacing Modules
- Appendix A – Interface Pin Allocations
- Appendix B – Inter-Module Connections
- Glossary
- Tait Software License Agreement
- Directive 1999/5/EC Declaration of Conformity
DRAFT 1
112 Appendix B – Inter-Module Connections TB9300 Installation and Operation Manual
© Tait Limited May 2013
Single 50W Base Station
The connections between modules at the front of a single 50W base station
are shown below.
DC Supply The PA is powered by a direct connection from the PMU. The reciter is
powered from the PMU via the subrack interconnect board and system
control bus ribbon cable.
Single 50W base station inter-module connections
b
28VDC output for PA
f
system control bus and 28VDC input
c
not used
g
RF output to PA
d
RF input from reciter
h
system control bus
e
28VDC input cable from PMU
i
28VDC output to subrack interconnect board
PMU
reciter
PA
bde
fghhi
c