User's Manual
Table Of Contents
- Installation and Operation Manual Draft in Progress
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Working with Base Stations from Your PC
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Configuring Single Base Stations
- 4.4.6 Configuring Base Stations in a Channel Group
- 4.4.7 Setting Up Custom Alarms
- 4.4.8 Disabling the Front Panel Keypad
- 4.4.9 Preparing to Download Firmware
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- 8 Replacing Modules
- Appendix A – Interface Pin Allocations
- Appendix B – Inter-Module Connections
- TaitNet P25 Glossary
- Tait Software License Agreement
DRAFT 4
80 Installation TB9400 Installation and Operation Manual
© Tait Electronics Limited September 2011
5.6 Connecting Up the Base Station
This section provides information relevant to the task of connecting up the
various inputs and outputs of the base station.
5.6.1 Connection Overview
The connections at the rear of a dual 50 W base station are identified in
Figure 5.7. External connections are all located at the rear of the subrack.
Figure 5.7 50 W base station inputs and outputs
b serial RS-232 connector
a
h + VDC input
c 1 PPS input i auxiliary DC output
d external reference frequency input j AC mains input
e RF input 1) Ethernet interface connector
f RF output 1! subrack ground connector
g – VDC input 1@ system interface connector
a. Factory use only.
PA 1Reciter 1 PMU
bcd
e
fgh
ij1)1!
1@
PA 2Reciter 2