User's Manual
Table Of Contents
- Installation and Operation Manual Draft in Progress
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Working with Base Stations from Your PC
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Configuring Single Base Stations
- 4.4.6 Configuring Base Stations in a Channel Group
- 4.4.7 Setting Up Custom Alarms
- 4.4.8 Disabling the Front Panel Keypad
- 4.4.9 Preparing to Download Firmware
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- 8 Replacing Modules
- Appendix A – Interface Pin Allocations
- Appendix B – Inter-Module Connections
- TaitNet P25 Glossary
- Tait Software License Agreement
DRAFT 4
30 General Safety and Regulatory Information TB9400 Installation and Operation Manual
© Tait Electronics Limited September 2011
properly, stop the module safely and contact your regional Tait office
immediately.
All servicing should be carried out only when the PMU is powered through
a mains isolating transformer of sufficient rating.
2.1.3 AC Power Connection
2.1.4 Explosive Environments
Warning!! Do not operate the equipment near electrical
blasting caps or in an explosive atmosphere.
Operating the equipment in these environments
is a definite safety hazard.
2.1.5 Proximity to RF Transmissions
Do not operate the transmitter when someone is standing within 3 ft (90 cm)
of the antenna. Do not operate the transmitter unless you have checked that
all RF connectors are secure.
2.1.6 High Temperatures
Take care when handling a PMU or PA which has been operating recently.
Under extreme operating conditions (+ 140° F [+60° C] ambient air
temperature) or high duty cycles, the external surfaces of the PMU and PA
can reach temperatures of up to + 176° F (+ 80° C).
2.1.7 LED Safety (EN 60825-1)
This equipment contains Class 1 LED Products.
English (en) The PMU must be connected to a grounded mains
socket-outlet.
Norsk (no) Apparatet må tilkoples jordet stikkontakt.
Suomi (fi) Laite on liitettävä suojamaadoitus-koskettimilla
varustettuun pistorasiaan.
Svenska (sv) Apparaten skall anslutas till jordat uttag.