User's Manual
Table Of Contents
- Installation and Operation Manual Draft in Progress
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Working with Base Stations from Your PC
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Configuring Single Base Stations
- 4.4.6 Configuring Base Stations in a Channel Group
- 4.4.7 Setting Up Custom Alarms
- 4.4.8 Disabling the Front Panel Keypad
- 4.4.9 Preparing to Download Firmware
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- 8 Replacing Modules
- Appendix A – Interface Pin Allocations
- Appendix B – Inter-Module Connections
- TaitNet P25 Glossary
- Tait Software License Agreement
DRAFT 4
16 Description TB9400 Installation and Operation Manual
© Tait Electronics Limited September 2011
Figure 1.3 below shows the configuration for a typical 100 W base station.
The PMU occupies its usual slot at the left end of the subrack, with the PA
directly beside it. The reciter occupies the slot at the right of the subrack.
Unlike the 50 W PAs, the 100 W PA is mounted horizontally with the
heatsink facing upwards. It is also fitted with an airflow duct to channel the
airflow from the cooling fan through the heatsink fins.
Figure 1.3 Mechanical assembly - single 100 W base station
b PMU e reciter
c PA f subrack
d airflow duct g cable retaining clip
b
c
d
e
f
g