User's Manual

104 Replacing Modules TB9300 Installation and Operation Manual
© Tait Limited March 2017
Refitting 1. Slide the replacement reciter into the subrack and secure it with the
retaining clamp.
2. Reconnect all the front and rear panel cables previously
disconnected. Ensure the front panel cables are positioned correctly,
and retained where required by the cable retaining clips in the top of
the subrack (refer to
“Appendix B – Inter-Module Connections” on
page 113
).
3. Tighten the nut on the SMA connector to a torque of 5lbf·in
(0.6N·m).
4. Carry out the instructions in
“Final Reassembly” on page 110.