User's Manual
Table Of Contents
- Installation and Operation Manual
- Tait Contact Information
- Contents
- Preface
- 1 Introduction
- 2 Mechanical Description
- 3 Functional Description
- 4 Installation
- 5 Replacing Modules
- 5.1 Removing the Base Station and Opening the Tray
- 5.2 Replacing the UI Board
- 5.3 Replacing the Receiver Module
- 5.4 Replacing the Transmitter Module
- 5.5 Replacing the SI Board
- 5.6 Replacing the Transmitter and Receiver Fans
- 5.7 Replacing the Fan Power Board
- 5.8 Replacing the Temperature Sensor Board
- 5.9 Replacing the AC Power Supply Unit, Fan and Filter Module
- 5.10 Replacing the Speaker
- 5.11 Final Reassembly
- 6 Connections
- 7 Preparation for Operation
- 7.1 Introduction
- 7.2 Mode of Operation
- 7.3 Line-controlled Base
- 7.4 Talk Through Repeater
- 7.5 RF Modem
- 7.6 Data Repeater
- 7.7 TaitNet Trunking
- 7.8 Programmable Features
- 7.9 Additional Settings
- 7.10 Adding Subaudible Signalling
- 7.11 Soft Off (Tx Tail Time)
- 7.12 Tone On Idle (TOI)
- 7.13 Fan Operation
- 7.14 Channel ID
- 7.15 Relay Polarity
- 7.16 Channel Increment and Decrement by Function Keys
- 7.17 Carrier Wave Identification (CWID)
- 8 Maintenance Guide
- Glossary
- Tait General Software Licence Agreement
- Directive 1999/5/EC Declaration of Conformity
70 Connections TB7100 Installation and Operation Manual
© Tait Electronics Limited December 2005
Serial Data
Connector (IOIOI)
The serial data connector (J1054) labelled IOIOI is a 9-way female D-range
connector, which provides a data connection to the base station.
Programming/Micro
phone Connector
(PROG/MIC)
The PC running the programming and calibration application is connected
to the base station via the programming/microphone connector (SK3) of
the UI board. The programming/microphone connector is an 8-way RJ45
socket.
Use the TPA-SV-006 or the T2000-A19 programming lead and a
TMAA20-04 adapter to connect the PC to the base station. It is possible to
plug the RJ11 directly into the RJ45 socket without the use of the adapter,
but this is not recommended. A microphone can also be connected to the
base station via this connector.
Pin Signal Name Signal Type Notes
1 not connected not used
2 receive data output data transmitted by TB7100
3 transmit data input data received by TB7100
4 not connected not used
5 ground ground
6 not connected not used
7 ready to transmit output request to send
8 clear to send input clear to send
9 not connected not used
h
j
b
g
i
c
d
e
f
external view
Pin Signal Name Signal Type Notes
1 not connected not connected
2 +13V8_SW output +13.8V, 250mA
3 TXD input transmit data
4 PTT input PTT
5 MIC_AUD_IN input voice band (microphone) input
6 GND ground
7 RXD output receive data
8 not connected not connected
12345678
external view