User's Manual
Table Of Contents
- Installation and Operation Manual
- Tait Contact Information
- Contents
- Preface
- 1 Introduction
- 2 Mechanical Description
- 3 Functional Description
- 4 Installation
- 5 Replacing Modules
- 5.1 Removing the Base Station and Opening the Tray
- 5.2 Replacing the UI Board
- 5.3 Replacing the Receiver Module
- 5.4 Replacing the Transmitter Module
- 5.5 Replacing the SI Board
- 5.6 Replacing the Transmitter and Receiver Fans
- 5.7 Replacing the Fan Power Board
- 5.8 Replacing the Temperature Sensor Board
- 5.9 Replacing the AC Power Supply Unit, Fan and Filter Module
- 5.10 Replacing the Speaker
- 5.11 Final Reassembly
- 6 Connections
- 7 Preparation for Operation
- 7.1 Introduction
- 7.2 Mode of Operation
- 7.3 Line-controlled Base
- 7.4 Talk Through Repeater
- 7.5 RF Modem
- 7.6 Data Repeater
- 7.7 TaitNet Trunking
- 7.8 Programmable Features
- 7.9 Additional Settings
- 7.10 Adding Subaudible Signalling
- 7.11 Soft Off (Tx Tail Time)
- 7.12 Tone On Idle (TOI)
- 7.13 Fan Operation
- 7.14 Channel ID
- 7.15 Relay Polarity
- 7.16 Channel Increment and Decrement by Function Keys
- 7.17 Carrier Wave Identification (CWID)
- 8 Maintenance Guide
- Glossary
- Tait General Software Licence Agreement
- Directive 1999/5/EC Declaration of Conformity
TB7100 Installation and Operation Manual Connections 65
© Tait Electronics Limited December 2005
6 Connections
Overview This section gives an overview of looms and cables, and describes the
specifications and pinouts of the external and internal connectors.
Figure 6.1 provides an overview of the connections.
For information on the factory connector and the internal options
connector of the transmitter and receiver, refer to the PCB information.
Figure 6.1 Connectors, looms and cables
DC Input
Connector
System
Connector
Serial Data
Connector
AC Input
Connector
Rx
Connector
Tx/Ant
Connector
Ground
Point
Transmitter
Module
UI Board
AC
Power Supply
Unit
Fan
FanFan
Fan Power Board
Speaker
Temperature
Sensor
Prog/Mic
Connector
Receiver/SI
DC power
RF
Transmitter/SI
RF
Receiver/UI
Transmitter/UI
AC Input Filter
Module
115V/230V
Selector
Switch
SI Board
Fuse
Mains fail signal
SK100
PL100
SK101
SK103
SK100
PL100
SK101
SK103
RF connector
DC power
connector
Auxiliary
connector
User interface
connector
Receiver
Module
RF connector
DC power
connector
Auxiliary
connector
User interface
connector
J102
J103
J105
J106 J104
J201
J200
J110
J100
J202
J101
DC power
Fan power
SK1
SK3
SK2
PL2PL7PL8
PL4
PL3
PL5
PL6
Factory
only
PL101
J600
DC Output
AC power
Configuration with internal AC power supply unit shown