User's Manual
Table Of Contents
- Installation and Operation Manual
- Tait Contact Information
- Contents
- Preface
- 1 Introduction
- 2 Mechanical Description
- 3 Functional Description
- 4 Installation
- 5 Replacing Modules
- 5.1 Removing the Base Station and Opening the Tray
- 5.2 Replacing the UI Board
- 5.3 Replacing the Receiver Module
- 5.4 Replacing the Transmitter Module
- 5.5 Replacing the SI Board
- 5.6 Replacing the Transmitter and Receiver Fans
- 5.7 Replacing the Fan Power Board
- 5.8 Replacing the Temperature Sensor Board
- 5.9 Replacing the AC Power Supply Unit, Fan and Filter Module
- 5.10 Replacing the Speaker
- 5.11 Final Reassembly
- 6 Connections
- 7 Preparation for Operation
- 7.1 Introduction
- 7.2 Mode of Operation
- 7.3 Line-controlled Base
- 7.4 Talk Through Repeater
- 7.5 RF Modem
- 7.6 Data Repeater
- 7.7 TaitNet Trunking
- 7.8 Programmable Features
- 7.9 Additional Settings
- 7.10 Adding Subaudible Signalling
- 7.11 Soft Off (Tx Tail Time)
- 7.12 Tone On Idle (TOI)
- 7.13 Fan Operation
- 7.14 Channel ID
- 7.15 Relay Polarity
- 7.16 Channel Increment and Decrement by Function Keys
- 7.17 Carrier Wave Identification (CWID)
- 8 Maintenance Guide
- Glossary
- Tait General Software Licence Agreement
- Directive 1999/5/EC Declaration of Conformity
110 Preparation for Operation TB7100 Installation and Operation Manual
© Tait Electronics Limited December 2005
Transmitter User-
defined Settings
The user-defined settings for the transmitter are shown below. The cells in
grey denote that the value should stay as detailed because of other
constraining settings
Form Tab Item Name Value Range Tx
Data General Transparent Mode
Enabled
Enabled / Disabled Enabled
Data General THSD_Modem_
Enabled
Enabled / Disabled Enabled
Data Serial Communications FFSK_Transparent_
Mode_Baudrate
1200, 2400, 4800, 9600,
14400, 19200, 28800
19200
Data Serial Communications THSD_Transparent_
Mode_Baudrate
1200, 2400, 4800, 9600,
14400, 19200, 28800
19200
Basic Settings Basic Network Settings TX Timer Duration 0…250 0
Basic Settings Basic Network Settings TX Lockout Duration 0…250 0
Basic Settings Sub Audible Signalling CTCSS Lead Out Delay 0…1000 0
Basic Settings Sub Audible Signalling Invert Tx DCS Enabled, Disabled Disabled
Basic Settings Sub Audible Signalling DCS Lead Out Delay 0…1000 0
Channels Detailed TX_Frequency 000.000000…
999.999999
See Note 1
Channels Detailed TX Sig CTCSS tone OR DCS tone none
Channels Detailed Power off, very low, low,
medium, high
high
Channels Detailed Network 1…4 1
Channels Detailed Bandwidth 12.5, 20, 25 12.5
Channels Detailed Use_Channel_For_
Data
Enabled, Disabled Disabled
Key Settings Key 1 Key Action see Key Action type none
Key Settings Key 2 Key Action see Key Action type none
Key Settings Key 3 Key Action see Key Action type none
Key Settings Key 4 Key Action see Key Action type none
UI
Preferences
User Interface Backlight Mode off, activity, continuous off
UI
Preferences
User Interface Backlight Duration 0…15 5
PTT MIC PTT PTT Transmission Type none, voice, data Voice
PTT External PTT 1 PTT Transmission Type none, voice, data Voice