User's Manual
Table Of Contents
- Installation and Operation Manual
- Tait Contact Information
- Contents
- Preface
- 1 Introduction
- 2 Mechanical Description
- 3 Functional Description
- 4 Installation
- 5 Replacing Modules
- 5.1 Removing the Base Station and Opening the Tray
- 5.2 Replacing the UI Board
- 5.3 Replacing the Receiver Module
- 5.4 Replacing the Transmitter Module
- 5.5 Replacing the SI Board
- 5.6 Replacing the Transmitter and Receiver Fans
- 5.7 Replacing the Fan Power Board
- 5.8 Replacing the Temperature Sensor Board
- 5.9 Replacing the AC Power Supply Unit, Fan and Filter Module
- 5.10 Replacing the Speaker
- 5.11 Final Reassembly
- 6 Connections
- 7 Preparation for Operation
- 7.1 Introduction
- 7.2 Mode of Operation
- 7.3 Line-controlled Base
- 7.4 Talk Through Repeater
- 7.5 RF Modem
- 7.6 Data Repeater
- 7.7 TaitNet Trunking
- 7.8 Programmable Features
- 7.9 Additional Settings
- 7.10 Adding Subaudible Signalling
- 7.11 Soft Off (Tx Tail Time)
- 7.12 Tone On Idle (TOI)
- 7.13 Fan Operation
- 7.14 Channel ID
- 7.15 Relay Polarity
- 7.16 Channel Increment and Decrement by Function Keys
- 7.17 Carrier Wave Identification (CWID)
- 8 Maintenance Guide
- Glossary
- Tait General Software Licence Agreement
- Directive 1999/5/EC Declaration of Conformity
104 Preparation for Operation TB7100 Installation and Operation Manual
© Tait Electronics Limited December 2005
7.6.5 Data Repeater Functional Testing
In order to verify the correct operation as a data repeater a basic functional
test can be carried out. This involves sending data from one TM8000 mobile
radio to another TM8000 through the TB7100 base station.
The following equipment will be required:
■ DC power supply
■ antenna for receiver input
■ dummy load for transmitter output
■ two TM8000 mobile radios capable of sending and receiving the
required data format.
■ two PCs running the terminal application.
■ programming cables for the TM8000 mobile radios.
The test set-up is shown in Figure 7.10 on page 104.
The correct operation of the base station as an RF modem can be verified
by transferring text files between the two PCs.
7.7 TaitNet Trunking
The TB7100 base station can be configured to work with a T1810 or T1711
to form part of a TaitNet MPT1327 Trunking System.
For more information, refer to the technical note TN-1033-AN “Using the
Tait TB7100 in TaitNet MPT1327 Trunked Networks” available from
http://support.taitworld.com.
Figure 7.10 Data repeater test setup
Receiver
Transmitter
System Interface
Dummy Load
Antenna
TM8000 Mobile
Radio
PROG/MIC Tx/Rx CHANNEL POWER Tx BUSY F1 F3 F4F2 VOLUME
TM8000 Mobile
Radio
Terminal
Application
Terminal
Application