User's Manual
Table Of Contents
- Installation and Operation Manual
- Tait Contact Information
- Contents
- Preface
- 1 Introduction
- 2 Mechanical Description
- 3 Functional Description
- 4 Installation
- 5 Replacing Modules
- 5.1 Removing the Base Station and Opening the Tray
- 5.2 Replacing the UI Board
- 5.3 Replacing the Receiver Module
- 5.4 Replacing the Transmitter Module
- 5.5 Replacing the SI Board
- 5.6 Replacing the Transmitter and Receiver Fans
- 5.7 Replacing the Fan Power Board
- 5.8 Replacing the Temperature Sensor Board
- 5.9 Replacing the AC Power Supply Unit, Fan and Filter Module
- 5.10 Replacing the Speaker
- 5.11 Final Reassembly
- 6 Connections
- 7 Preparation for Operation
- 7.1 Introduction
- 7.2 Mode of Operation
- 7.3 Line-controlled Base
- 7.4 Talk Through Repeater
- 7.5 RF Modem
- 7.6 Data Repeater
- 7.7 TaitNet Trunking
- 7.8 Programmable Features
- 7.9 Additional Settings
- 7.10 Adding Subaudible Signalling
- 7.11 Soft Off (Tx Tail Time)
- 7.12 Tone On Idle (TOI)
- 7.13 Fan Operation
- 7.14 Channel ID
- 7.15 Relay Polarity
- 7.16 Channel Increment and Decrement by Function Keys
- 7.17 Carrier Wave Identification (CWID)
- 8 Maintenance Guide
- Glossary
- Tait General Software Licence Agreement
- Directive 1999/5/EC Declaration of Conformity
100 Preparation for Operation TB7100 Installation and Operation Manual
© Tait Electronics Limited December 2005
7. Open the data form and in the general tab:
■ In the command mode section disable all check boxes.
■ In the transparent mode section select transparent mode enabled
and THSD modem enabled and de-select the ignore escape
sequence check box.
■ Set Power Up State to THSD transparent mode.
8. Open the data form and in the serial communications tab:
■ In the serial communications setup field set the THSD transparent
mode baud rate to 9600, the Flow control to None and the data
port to the required data port.
■ Ensure hardware flow control is set to None.
9. Open the data form RF modems tab. The FFSK modem settings do
not apply and can be ignored. In the THSD modem section set up
the following:
■ Wide band modem enabled
■ Layer 2 Protocol enabled
■ Forward Error Correction disabled
■ THSD Lead-In Delay default of 30ms is acceptable.
10. Program the receiver.
7.5.9 Verification
In order to verify the correct operation as an RF modem a basic functional
test can be carried out by sending data between the TB7100 base station and
a TM8000 mobile radio.
The following equipment will be required:
■ DC power supply
■ antenna for receiver input
■ dummy load for transmitter output
■ a PC running the terminal application connected to the serial data port
on the base station with a 9-pin serial cable
■ a second PC running the terminal application connected to a TM8000
mobile radio which has been programmed to send and receive the
required data modulation (FFSK or THSD).
The test setup is shown in “RF modem test setup” on page 101.