User's Manual

TB7100 Installation Guide Installation 11
© Tait Electronics Limited May 2005
1.8.3 Cabling
General We recommend that you try to route all cables to and from the TB7100 base
station along the side of the cabinet so the cooling airflow is not restricted.
DC Power Cabling DC power cables should be well supported so that the terminals on the base
station and on the ends of the cables do not have to support the full weight
of the cables.
The Figure 1.4 on page 12 shows two recommended methods of securing
these cables to prevent straining either set of terminals.
Figure 1.3 Base station mounting points
b
main mounting holes - front
e
ground point
c
TB7100 base station
f
rack frame
d
DC connector - rear
rear view
f
d
c
e
b