User's Manual
Table Of Contents
- Specifications Manual
- Tait Contact Information
- Contents
- Preface
- 1 System Specifications
- Supply
- Power Consumption @ 13.8 VDC
- Power Consumption Band B1, 25 W*
- Power Consumption Band B1, 50 W*
- Power Consumption Band H5, 25 W*
- Power Consumption Band H5, 40 W*
- Power Consumption Band H6, 25 W*
- Power Consumption Band H7, 40 W*
- Transmitting into 5:1 VSWR*
- Channel Data
- Environmental
- Physical
- Isolation
- RF Compliance
- EMC Compliance
- Environmental Compliance
- Safety Compliance
- General
- 2 Receiver Specifications
- 3 Transmitter Specifications
TB7100 Specifications Manual Transmitter Specifications 23
© Tait Electronics Limited May 2005
3 Transmitter Specifications
This chapter provides specifications pertaining to the transmitter module.
The performance figures given in these specifications are applicable only to
the transmitter module operating as an integral part of a TB7100 base
station. These performance figures are minimum figures, unless otherwise
indicated (typical), for equipment operating at standard room temperature
(+22°C to +28°C [+71.6°F to +82.4°F]) and standard test voltage (12
VDC).
Where applicable, the test methods used to obtain these figures are those
described in the ANSI/TIA-603-B-2002 and ETSI-EN specifications. This
equipment is compatible with F3E and G3E emissions. You can obtain
further details of test methods and the conditions which apply for
compliance testing in all countries from Tait Electronics Limited.
Bandwidth The terms “narrow bandwidth”, “mid bandwidth” and “wide bandwidth”
used in this chapter are defined in the following table.
Channel Spacing
Modulation
100% Deviation
Receiver
IF Bandwidth
Narrow Bandwidth
(NB)
12.5 kHz ± 2.5 k Hz 7.5 kHz
Mid Bandwidth
(MB)
20 kHz ± 4 kHz 12 kHz
Wide Bandwidth
(WB)
25 kHz ± 5.0 kHz 15.0 kHz