User's Manual

32 Operating Controls TB8100 Installation and Operation Manual

Alarm LED

The red alarm LED will flash at a rate of 2 to 5Hz when an alarm has been

generated by any of the TB8100 BSS modules. It will continue to flash until

the alarm is cancelled or the fault is fixed. Note that only those alarms which

are enabled using the Service Kit (Configure > Alarms > Alarm Control)

will cause this LED to flash. Refer to the Service Kit documentation for

more information.

Base Station 1

Select Button

Pressing this button selects base station 1. Pressing the button again while

base station 1 is selected has no effect. When the BSS is powered up, the

control panel selects base station 1.

Power LED The green power LED is lit when the PMU is turned on and supplying

power to the BSS.

Base Station 2

Select Button

Pressing this button selects base station 2. Pressing the button again while

base station 2 is selected has no effect.

3.1.3 Power Save Control Panel

The indicator LEDs on the power save control panel are identified in

Figure 3.3 below.

Figure 3.3 LED indicators on the power save control panel

power LED

alarm LED