User's Manual

22 Connection TB8100 Installation Guide
© Tait Electronics Limited June 2005
Isolated E&M
This system interface board is fitted to reciters bearing the product code
TBA4xxx-0C0x or TBA5xxx-0C0x. If purchased separately, it has the
product code TBA10C0. It provides the following:
It is fitted with a 25-way female D-range connector and a 4-way auxiliary
DC input connector. The pin allocations for the D-range are listed in the
table below, and the pin allocations for the DC input connector are provided
in “Reciter Auxiliary DC Input from PMU” on page 18.
transformer isolated 600 balanced audio I/O
opto-isolated keying
opto-isolated gate output
digital I/O (2 outputs, 2 inputs, 4 bi-directional)
Tx key
Tx relay
Rx gate
RSSI
Pin Signal Name Signal Type Notes
1 Rx line out +
audio output transformer isolated line
2 Rx line out –
3 Rx audio out audio output
4 audio ground ground
5 Tx audio in audio input
6 Tx line in +
audio input transformer isolated line
7 Tx line in –
8 RSSI DC signal
9 Rx gate output open collector
10 Tx key input active low
11 digital out 1
a
output open collector
12 digital out 2
13 +AUX_V power output from auxiliary DC input
14 digital in 1
input
5V TTL logic
active low
15 digital in 2
16 digital in/out 3
b
17 digital in/out 4
b
18 digital in/out 5
b
19 digital in/out 6
b
20 opto +/–
isolated keying input
input voltage range
±10VDC to ±60VDC
21 opto –/+
22 relay +/–
isolated gate output
23 relay –/+
24 Tx relay output open collector
25 ground ground
a. If a base station with a 12V PA is configured for Deep Sleep, digital out 1 is dedicated to Power Saving control and
should not be used for any other Task Manager function.
b. On version 1 and later system interface boards, digital inputs 3, 4, 5, and 6 may also be configured as outputs using
a Task Manager statement. For more details refer to “Digital Interface” on page 117 of the Installation and Oper-
ation Manual, and to the Service Kit documentation.
external view
B
C
D
E
F
G
H
I
J
1)
1!
1@
1#
1$
1%
1^
1&
1*
1(
2)
2!
2@
2#
2$
2%