User's Manual Part 5
* (,
&
All sub-assemblies within the T2008 power supply (e.g. transformer, PCB/heatsink) are
housed in a specially moulded plastic case with no screws. The top and bottom halves
of the plastic case are fastened by four self-tapping screws.
All electrical components except the transformer and LED are mounted on either the
larger regulator/heatsink PCB or on the smaller mains input PCB.Disassembly
Disconnect the unit from the mains supply before attempting to remove
the top case.
!"#$%&
The power supply contains voltages that may be lethal. The unit should not be disman-
tled without first disconnecting the mains supply. Servicing should be carried out only
by qualified technicians.
!"%
If the power supply is operated at high output currents and/or a high duty cycle rate
for a prolonged period of time (e.g. more than 10 minutes), the heatsink will become
very hot. Do not touch.
Do not operate the power supply in a sealed cabinet. Ensure that there is an adequate
airflow past the unit and in particular past the heatsink at the back of the unit.
!"'!(
If the mains supply cord needs replacing, it must be replaced with a mains supply cord
of the same size and type as originally fitted.
),$!
Turn the unit upside down and remove the two self-tapping screws.
Turn the unit back on its feet and remove the two top screws.
Carefully lift the top case away from the unit.
All the sub-assemblies are now easily accessible, and can be lifted out as neces-
sary.