Service Manual Part 1
80
88"8 11:1"141+1
" $ " () * 2234 54 6()
Refer to Figure 3.5 and Figure 3.6.
Remove the control head from the main chassis, as instructed in Section 3.2.3.
Remove the four adaptor plate/remote back panel retaining screws (16). Remote
mounted models also have two captive nuts (17) fitted in the back cover.
EMC model radios have 4 ESD plugs fitted over the remote back panel screws.
These will need to be removed to access the remote back panel screws.
Remove the control head PCB retaining screws (14).
The screws used in the control head are No. 4 Plastites, and should not be con-
fused with the M3 screws used elsewhere. When being replaced, the No. 4 Plas-
tite screws must be tightened to a torque of 8in.lb (0.9Nm).
$
"
% ""#
& &
#
&
" *&! ' !' !
# ! #"
! $'! "
&
#
"
! (
) !
!
" ) !
4
10
9
6
5
12
3
2
1
15
7
8
16
11
13
14