User's Guide
Table Of Contents
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- Making a call
- Making an individual call
- Understanding talkgroups
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Receiving calls
- Communicating directly with other radios
- Checking that the channel is clear
- Using the radio in different repeater areas
- Hearing faint and noisy signals
- 6 Operating in P25 trunking mode
- 7 Scanning
- 8 P25 services
- 9 Location services
- 10 Emergency operation
- 11 Encryption
- 12 Customizing radio settings
- 13 Charging and caring for batteries
- 14 Troubleshooting
- 15 Glossary
- Simplified Declaration of Conformity
- Tait Software Licence Agreement
Before using your radio 37
Installing an audio accessory
Warning Use only Tait-supplied, IS and NI-approved
audio accessories with IS and NI radios. Fitting an
audio accessory that is not IS and NI-approved
exposes the customer to a risk of explosion which
could cause serious injury or death. For an up-to-date
list of approved audio accessories, contact your
regional Tait office. For detailed information about
IS and NI radios and how to identify them, see
"Intrinsically Safe and Non-Incendive radios and
accessories" on page 10.
Audio accessories plug into the radio’s accessory
connector. The accessory connector is protected by a
cover, which needs to be removed before an
accessory can be installed.
Notice The accessory cover protects the accessory
connector from electrostatic discharge. Keep the
cover in place unless the connector is in use.
To remove the accessory cover and install an audio
accessory:
1 Use a coin or other blunt object to loosen the screw
that secures the accessory cover to the radio.
2 Remove the accessory cover and store it in a safe
place.
3 Plug the accessory into the accessory connector.
4 Tighten the screw.