_User_Manual_Taisync_Pro_V1.00(HDMI-AV-HDMI)-EN-20200519

Insert the six-pin connector of supplied serial cable to the serial port of the air unit and

connect the other end of the serial cable to the telemetry port of a flight controller.

Insert the supplied RC cable to the RC port of the air unit and connect the other end of the

RC cable to the PPM/S.BUS port of a flight controller.

3.2.Ground Unit Installation

3.2.1. Antenna installation

Screw the ground unit antennas onto the RF ports. Make sure the antennas are tightly

installed.

Note:

(1) To avoid equipment damage, install antennas before powering on the units.

(2) Ensure the antenna connector is vertical to the module when it is screwed onto the RF

port. Screw the antenna tightly to avoid loose connection, but do not overtighten the

antenna to avoid damaging the antenna.

(3) Both antennas need to be installed.

(4) Adjust the antenna to be vertical to the ground during operation.