User's Manual

14
OEM Integration Instructions：
This device is intended only for OEM integrators under the following
conditions：
The module can be used to installation in other host. The antenna must be
installed such that 20 cm is maintained between the antenna and users,
and the transmitter module may not be co-located with any other transmit
or antenna. The module shall be only used with the integral antenna(s)
that has been originally tested and certified with this module. As long as 3
conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-
product for any additional compliance requirement with this module
installed (for example, digital device emission, PC peripheral requirements,
etc.)
IMPORTANT NOTE：
In the event that these conditions cannot be met (for example certain
laptop configuration or co-location with another transmitter), then the FCC
authorization for this module in combination with the host equipment is no
longer considered valid and the FCC ID of the module cannot be used on
the final product. In these and circumstance, the OEM integrator will be
responsible for re-evaluating. The end product (including the transmitter)
and obtaining a separate FCC authorization. The final end product must
be labeled in a visible area with the following: “Contains Transmitter
Module FCC ID: 2AQVB-T19V0315 or Contains FCC ID: 2AQVB-
T19V0315”.