Instructions / Assembly
3
Attach rollers to hanger clips on both panels. Rollers should be mounted so that the head of the
mounting screw is on the same side of the panel as the screw head set into the hanger clip (see
inset drawing).
STEP 1
Measure opening on bottom and cut Bottom track (pa②) 1/8" shoer than opening.
STEP 2
Place wall jamb down over bottom track so that the back of the jamb is between the bottom
track and the wall. Using a level to insure jamb is plumb, mark hole locations. Remove jamb and
drill holes about 1 1/2" deep at each of the marked locations.
STEP 3
NOTE: When drilling into ceramic, glass, or stone, use a 1/4" MASONRY drill bit. When installing
on berglass or aclic, use a 1/8" drill bit and discard the wall plugs. When installing on
berglass or aclic, you may need to le the side jambs at the bottom to t the contour of the
unit.For dwall that is more than 10-12mm in thickness, please ensure you use specied dwall
anchors for installation. If the dwall is less than 10-12mm in thickness, make sure to install the
brackets on the stud.
NOTE: The various holes in the hanger clip are used to ne tune the adjustment of the panel to
make up for walls that are slightly out of square or plumb, For best results sta with all rollers in
the second hole from the top and then make adjustments as needed.
STEP 2
STEP 1
STEP 3
GLASS HANGER
ROLLER
SCREW
DOOR PANEL(OUTSIDE)
DOOR PANEL(INSIDE)
L=actual openimg - 1/8"