User's Manual

A1-50

Data transmission via Bluetooth (For FORA D40b only)

STEP 1

With the monitor turned off, press the RF button to initiate the data

transmission of the monitor. “PCL” will appear on the display and the RF

indicator will light up in blue.

When the RF indicator is blinking fast, indicating the monitor is still searching

for pairing. When the RF indicator is blinking slowly, indicating the monitor has

found the pairing computer. When the RF indicator is in steady blue light,

indicating the monitor is online and ready for data transmission.

STEP 2

Follow the instructions provided in the software to transmit data (results and

their corresponding dates and times). Press the RF button or the On/Off

button and the monitor will turn off.

NOTE

 Make sure your PC has Bluetooth before transmitting the data and the

monitor is within the receiving range.

 When reviewing the test result by pressing the M button (page 45), you can

press the RF button and just upload one single test result.

 Only one data transmission is allowed at one time. If the RF button has been

pressed while the USB cable is still connecting the monitor with PC, the

monitor can only communicate through USB cable rather than the wireless

transmission.