Installation Guide

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are



Hardware accepts no liability for any damage to the

faucet, plumbing, sink, wall, or for personal injury during







any damage is found, contact our Customer

Relations 303- 747-4321

Ensure that you have gathered all the required



For these instructions, it is assumed that the old

faucet has been completely removed and any neces-







TOOLS AND MATERIALS:

Plumber’s Tape

Drill





Level



(provided)

Flathead



Pipe Clamps

PAGE 1
WALL-MOUNT FAUCET TOOLS AND MATERIALS: BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing �xtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, wall, or for personal injury during installation. Plumber’s Tape Drill Thread Sealant Tape Measure Level Hex Wrench (provided) Flathead Screwdriver Pipe Clamps Observe all local plumbing and building codes. Unpack and inspect the faucet for shipping damage.
PAGE 2
WALL-MOUNT FAUCET INSTALLATION 3. Attach your existing water lines to the valve body. Apply thread sealant or plumber’s tape to the threaded connection to ensure a watertight seal. 1. Prepare for installation by installing wood blocking between the two studs where the faucet will mount. Important: Take into consideration the thickness of your �nished wall materials, such as tile, when calculating measurements.
PAGE 3
WALL-MOUNT FAUCET 5. Slide the decorative escutcheons onto the installed valve body, as shown. 7. Attach the lever handle by sliding it onto the valve stem. Remove the screw cover located on the bottom of the handle, and tighten the set screw to secure. Reinsert the screw cover. Set Screw Screw Cover 6. Attach the spout to the valve by threading it into its outlet, as shown. Apply plumber’s tape or a small amount of thread sealant to the threads before attaching. 8.