User Manual

Medio S004 EVM
The next step is to install the VCP drivers.
Power up and connect your Medio S004 to a spare USB port on your PC. This will launch the
Windows Found New Hardware Wizard
Select “No, not this time” and click next to proceed with the installation
Select “Install from a list or specific location (Advanced)” and then click “Next”
Select “Search for the best driver in these locations” and click the Browse button to select
the USB Drivers folder on the Product CR-Rom. Then click “Next” to proceed.
Windows should then display a message indicating that the installation was successful.
Click Finish to complete the installation. This has installed the serial converter. The COM
port emulation driver must be installed after this has completed.
After clicking “Finish”, the Found New Hardware Wizard will continue by installing the COM
port emulation driver.
To confirm that the installation has completed successfully, open the Device Manager and select
“View > Devices by type”. The TAGSYS Medio S004 appears as an additional COM port.
18/33 Revision 1.1 October 2006