User Manual

Installing the Reader
April 2008 Revision 2.2 15/41
4 Installing the Reader
This section describes how to install the Medio P101-Ethernet reader.
4.1 Reader Connections
4.1.1 Front Panel
The front panel is dedicated to RF and I/O connectors:
Figure 1: Front panel
• RF antenna connector:
Any of the following antennas can be connected to the standard SMA connector:
Antennas that apply to CE rules
• L-W1 • Aero LI
• TR-HA1 • L-SA3
• Leds
The red LED lights on continuously when the power supply voltage is correct.
If the red LED is blinking the power supply voltage is insufficient.
During firmware downloading the red Led is blinking.
The green Led is turned on when the output I/O connector is active.
I/O
connector
Green Led
Red Led
RF antenna
connector