User's Manual

Library L100 Reader User's Guide
CAUTION: The antenna MUST be connected to the reader unit before the reader is turned on.
When your application is fully developed and ready for use, configure the Main Operating mode:
1. Connect the antennas to the required inputs, according to application specifications.
2. Connect the L-L100 Reader serial port to the PC or to the terminal using a serial cable.
3. Connect the pull-up supply and I/O ports if required.
4. Make sure that the monitoring port is not connected to the parallel cable.
5. Connect the L-L100 Reader to the AC supply.
The Application software stored in Data Processing Unit is now running and the application is
ready for use.
26/45 Revision 3.1b April 2003