User Manual

Configuration
Suspend EAS
Click the button to stop EAS detection. Another click resumes EAS detection.
Once you have set the basic configuration check that all the slaves are well synchronized. To do
so, L-SP2 electronics unit green LEDs should flicker cyclically. If not, proceed to the advanced
configuration stage.
Database
Each time an item (with EAS activated) passes through the gates an entry is added to a local
database in L-SP2 memory. This entry holds the following information:
 The date and time to which the theft was committed.
 The chip type (C220, C320, C270 or C370).
 The memory data If “Read ID” is activated.
The database section shows the number of entries stored in L-SP2 memory in real-time.
Access Database
To access the database, click “Access Database” :Database is downloaded and the following
window is displayed:
Figure 13: Database
CAUTION: When this window is open EAS detection is automatically suspended. It is
resumed when the window is closed.
December 2004 Revision 1.0 27/50