User Manual

LIBRARY SECURITY PEDESTAL 2
5.3 Configuration of the L-SP2
Before you configure the whole L-SP2, you need to have a clear vision of which systems will
be the Masters or the Slaves. (Refer to
section 5.1,”Understand the EAS Pedestals
Synchronization Process “)
CAUTION: In a configuration case with several pedestals, as pedestal are default Master
configured, they will mutually perturb when powered on. So the first step will be to set the
Slaves pedestals chosen as Slave.
5.3.1 Basic Configuration
Double-click on the application shortcut to start the application.
By default, the application searches for a serial L-SP2 connected to the COM Port 1.
If no L-SP2 is detected on this COM Port, the following window is displayed:
Figure 10:Main L-SP2 Configuration Utility Window
Alarm: icon lights ON
when EAS is detected
Motion: icon lights ON
if a motion is detected
by IR sensors
Select the COM Mode for your L-SP2 between Serial/USB and Ethernet.
 If Serial then select the Com Port (1 to 8 available)
 If Ethernet then enter its address and TCP port
Click “Reset Com” to establish communication to the L-SP2. If settings are correct the following
window is displayed:
24/50 Revision 1.0 December 2004