User Manual

Installation
4 Installation
4.1 L-SP2 EAS System Components
The components included in the L-SP2 EAS System package are listed in Table 1. The
entire kit is delivered in a box as shown in Figure 1.
Table 1: L-SP2 EAS System Components
Quantity Description
1
L-SP2 Pedestal
8 40 mm Philips-head, countersunk screws with a diameter of 6 mm
8 8 mm plastic cement plugs
1 L-SP2 EAS System CD-ROM
1 RS 232 cable
Figure 1: Delivery of L-SP2 EAS System Components
4.2 L-SP2 Pedestal
CAUTION: This equipment is intended for indoor use only under the conditions described in
this document. Should it be used outside these conditions cannot be guaranteed, and is not
recommended. Please read
section 1“ For Your Safety “ before installation or use.
4.2.1 Tools Required
The following tools are required during installation :
 Tape measure
 Square
 Drill with 4 mm, 8-mm and 19-mm bits
 Philips-head screwdriver
 Level
December 2004 Revision 1.0 15/50