User's Guide

Warranty Conditions
Appendix B: S002 Explorer
10.3 Verification of L-HR1 Performances
The S002 Explorer software tool is used to verify the reading performances of the L-HR1 Library
Handheld Inventory Reader.
Procedure:
9. Install the S002 Explorer software tool on your PC. (Compatible with Windows™ 9x, NT,
2000 and XP operating systems.)
10. Connect the Library Handheld Inventory Reader to the serial port of your PC and the power
supply connected.
11. Run the S002 Explorer software tool.
12. If the Library Handheld Inventory Reader is not detected (error message), adjust the
communication settings for the Library Handheld Inventory Reader.
a. In the Settings menu, open the Communication Settings submenu.
b. Select the communication port that is connected to the Library Handheld Inventory
Reader.
Figure 20: Adjusting Communication Settings
13. On the Settings menu, click General Reader Settings and set the following parameters as
listed below.
a. Place a book with a Folio 20 smart label on the Library Handheld Inventory Reader
antenna.
b. Set the Output Power selection to Full.
c. Check the Read Continuously button in the Default Read Parameters.
d. Click on Detect in the Default Read Parameters.
e. The 'C220 is now the default tag type' message is displayed.
July 2003 Revision 1.2 33/34