User's Guide

L-HR1 Library Handheld Inventory Reader User's Guide
7 Troubleshooting
7.1 Troubleshooting Procedures
In the event of any problems with the L-HR1 Library Handheld Inventory Reader, please perform
the following troubleshooting procedures.
1. Verify that the battery of the L-HR1 Library Handheld Inventory Reader is correctly charged.
If the Power LED of the unit is orange or red (or does not light up at all), its battery requires
charging.
Connect the L-HR1 to the battery charger and plug the battery charger to the mains supply.
The status LED on the battery charger is green when the L-HR1 is fully charged.
2. Verify that the iPAQ cable is correctly connected to the L-HR1 Library Handheld Inventory
Reader and that it is not damaged.
3. Verify that the L-HR1 Library Handheld Inventory Reader functions correctly by connecting
the unit directly to a PC and running the S002 Explorer software included in the CD-ROM.
For more information, refer to Appendix B: S002 Explorer.
In the event that the problem is not solved after performing these three steps, refer to Section 9,
“Warranty Conditions” to return the defective Product to TAGSYS if you are the original buyer.
Otherwise, please contact your TAGSYS approved representative.
26/34 Revision 1.2 July 2003