User's Manual

Page 9 of 11
Figure 1: shows Parakeet with Antenna positioned closest to lid opening point
1. Remove the pit lid and make TWO 5 mm size holes and as shown in the
figure below, spaced 80 mm apart. Feed a high quality cable tie through each holes so
that they loop through and around the locating grooves in the Parakeet. Securing it so
it does not move.
.
2. Tighten the cable ties so that the endpoint is secured to the top of the lid. Trim the
excess length of cable tie and keep a tidy site.
1
2
2
80 mm
1