User's Manual

Page 9 of 10

Figure 3: shows LORIKEET with Antenna positioned closest to lid opening point

1. Remove the pit lid and make TWO 5 mm size holes and as shown in the

figure below, spaced 80 mm apart. Feed a high-quality cable tie through each of the

holes so that they loop through and around the locating grooves in the LORIKEET.

Securing it so it does not move.

Figure 4: Drill hole spacing

2. Tighten the cable ties so that the endpoint is secured to the top of the lid. Trim the

excess length of cable tie and keep a tidy site.

80 mm