User's Manual

Page 5 of 10
4) Compatible Encoders/Registers
The following Encoders/Registers represent some of the many devices that connect to the
LORIKEET ENCODER endpoint
Honeywell SM700
Badger Meter High Resolution LCD
Encoder
5) LORIKEET Endpoint connector variations
Endpoint Configurations
Encoder Connection
Endpoint only with in-line connector
Connect the endpoint to an encoder using the
in-line connector.
Endpoint/Encoder assembly with inline
connector
Factory pre-wired; no splicing necessary
6) Installation Guidelines
Install the endpoint/encoder assembly according to these guidelines:
• Indoor/Outdoor installation:
o Indoor installation is recommended. Mount endpoints indoors, in the floor
joist near an outside wall and away from large metal objects.
o Outdoor installation is acceptable and may be required where signal strength
does not support indoor installation
o Pit installation: It is preferred that the LORIKEET Endpoints are mounted
through a non-metal pit lid. Otherwise, mount it as close to the underside of the
lid as possible (See Page 8 - Mounting Instructions).
NOTE: Incorrectly installed endpoints may not be covered under warranty.
7) Out of the Box
The endpoint is shipped in Flight Mode whereby it does not transmit. This serves multiple
purposes including ensuring maximum battery life and meeting safety and regulatory
restrictions relating to shipping radio transmitters.