Phau Ntawv Qhia
8
Stereo/Mono Models
STEREO CONNECTION MONO CONNECTION
Connect a single speaker to two amplier spe-
akers output terminals.
Connect one amplier speakers output termi-
nal with one speaker input terminal (RED + with
RED +, BLACK – with BLACK -), connect the
other amplier speakers output terminal with
the other speaker input terminal (RED + with
RED +, BLACK – with BLACK -).
Connect a single speaker to a single amplier
speakers output terminal.
Connect one amplier speakers output termi-
nal with one speaker input terminal (RED + with
RED +, BLACK – with BLACK -). Using a short
piece of speaker cable connect Left + (RED)
speaker input terminal with Right + (RED)
speaker terminal. Do the same for - terminals
(BLACK).
Run the speaker cable to location where the speaker is to be installed. Leave about 20 cm
(0.66 feet) of extra cable (if the speaker cable is hidden in a wall or ceiling make a hole in the
center of the location of the speaker).
• TOS using U mounting bracket with horizontal regulation:
- Run the speaker cable through an installation hole in the middle of the U bracket.
- Position the bracket on the wall or ceiling where you want to mount the speaker, and mark
places of mounting the screws.
- Screw the U mounting bracket onto the wall or ceiling where you want to mount the speaker.
- Connect the speaker cable to the speaker terminals.
- Slide the speaker into the U bracket and screw top and bottom bracket knobs to the speaker to
secure the speaker in the bracket.
- Adjust the horizontal position of the speaker and fasten (screw in rmly) the knobs. In the future
the knobs can be loosen to adjust the speaker horizontal position.
Speaker Mounting
Hooking Up the Wires
Depending on the mounting surface use appropriate screws or wall anchors
(ask your local dealer or installer for advice).