Instruction Manual
8
Hooking Up the Wires
The speaker terminal can accommodate up to 10 AWG speaker cables (selected
models only - others up to 14 AWG). 10 or 14 AWG speaker cables are recommended
for longer connections (greater than 20 meters / 66 feet). For shorter lengths you can
use 16 or 18 AWG speaker cables. It is recommended to leave about 150 cm (5 feet)
of extra cable at the speaker end to facilitate positioning and installation of the speaker.
Do not use staples, nails or other metal objects to secure the speaker cables. You will
get the best sound quality and least amount of hum by keeping the speaker cables
away from other electrical wires and cables.
Pay attention to connecting the polarity of the speaker correctly with the amplier
speakers output terminals (RED + with RED +, BLACK - with BLACK -). Before
connecting the speaker make sure that your amplier is switched off. Please refer to
your amplier’s instruction manual for more information.
Stereo/Mono Models
STEREO CONNECTION MONO CONNECTION
Connect a single speaker to two amplier
speakers output terminals.
Connect one amplier speakers output termi-
nal with one speaker input terminal (RED +
with RED +, BLACK – with BLACK -), connect
the other amplier speakers output terminal
with the other speaker input terminal (RED +
with RED +, BLACK – with BLACK -).
Connect a single speaker to a single amplier
speakers output terminal.
Connect one amplier speakers output termi-
nal with one speaker input terminal (RED +
with RED +, BLACK – with BLACK -). Using a
short piece of speaker cable connect Left
+ (RED) speaker input terminal with Right
+ (RED) speaker terminal. Do the same for
- terminals (BLACK).
Check whether your amplier may work with impedance of your TAGA
Harmony speaker. Otherwise you may burn the amplier and damage
the speakers - it may void your warranty.