Cov lus qhia

2/20/23, 10:32 AMRemoval And Installation (Air Bag Control Module) - ALLDATA Repair

Page 1 of 2https://my.alldata.com/repair/#/repair/article/51007/component/470/itype/401/nonstandard/660427/selfRefLink/true

2012 Nissan-Datsun Leaf ELE-Electric Engine

Vehicle > Restraints and Safety Systems > Air Bag Systems > Air Bag Control Module > Service and Repair >

Removal and Replacement > Diagnosis Sensor Unit

REMOVAL AND INSTALLATION

DIAGNOSIS SENSOR UNIT

Removal and Installation

WARNING:

Always observe the following items for preventing accidental activation.

- Before servicing, push power switch OFF, disconnect 12V battery negative terminal and wait for 5

minutes or more. Refer to "Precaution for Removing 12V Battery"

See: Restraints and Safety Systems >

Technician Safety Information > Precaution For Removing 12V Battery

- Before disconnecting the unit harness connector, be sure to disconnect the each harness

connector of the and pre-tensioner to prevent deployment by static electricity

and pre-tensioner seat belt operation.

air bag sensor

air bag module seat belt air bag

- Never use air tools or electric tools for servicing.

- When replacing the , always check with the parts department for the latest parts

information. Installing an incorrect air bag diagnosis sensor unit may or may not cause the air bag warning lamp

to illuminate and may cause incorrect deployment of the supplemental air bags and seat belt pre-tensioners in a

collision resulting in serious personal injury or death.

air bag diagnosis sensor unit

REMOVAL

1.Always check the air bag diagnosis sensor unit ECU discriminated number (identification number) using

CONSULT.

2.Disconnect the each connector of all air bag modules and pre-tensioner seat belts.

3.Remove the center console assembly. Refer to "Removal and Installation" See: Console > Removal and

Replacement > Removal And Installation.

4.Disconnect the diagnosis sensor unit harness connectors (A).

5.Remove the diagnosis sensor unit mounting bolts (B), and then remove the diagnosis sensor unit.

CAUTION:

PAGE 1
Removal And Installation (Air Bag Control Module) - ALLDATA Repair 2/20/23, 10:32 AM 2012 Nissan-Datsun Leaf ELE-Electric Engine Vehicle > Restraints and Safety Systems > Air Bag Systems > Air Bag Control Module > Service and Repair > Removal and Replacement > Diagnosis Sensor Unit REMOVAL AND INSTALLATION DIAGNOSIS SENSOR UNIT Removal and Installation WARNING: Always observe the following items for preventing accidental activation.
PAGE 2
Removal And Installation (Air Bag Control Module) - ALLDATA Repair 2/20/23, 10:32 AM - To prevent damage to the parts, never impact the diagnosis sensor unit. - Replace the diagnosis sensor unit if it is dropped or sustains an impact. - Replace the diagnosis sensor unit of deployed SRS air bag and deployed SRS front seat belt pre-tensioner. INSTALLATION Note the following items, and then install in the reverse order of removal. CAUTION: - Never reuse bolts after removal, replace with new bolts.