User Manual

15
www.staufenbiel-shop.com
[e-mail]
[phone]
EN
The control rods of the ailerons are preassem-
bled at the factory. Nevertheless, we recom-
mend checking all screw connections and
securing them with Loctite if necessary. Also use
a servo-tester to check whether the servos are in
the neutral position, as illustrated. If the rudder
area is now not neutral, the linkage lengths
must be adjusted.
Hook-in position of the aileron linkage:
Rudder - outermost
Servo - second hole from outside
5
Now connect the two landing aps, aileron
and landing gear with the enclosed Y-cables.
If there are enough channels at the receiver,
you can also dispense with the Y-cables, in
order to be able to trim the individual servos
more precisely. In this case, however, mixers
need to be programmed for all functions.
4a
Stow the Y-cables in the wing and make sure
that about 10-15 cm servo-cables protrude on
the right side in the direction of ight. Fasten the
cables with adhesive tape as shown in the gure.
4b
Check the screw connections of the landing
ap linkage as described above. Move the
servos of the landing aps using a servo-tester
into a 45° position (to the end strip).
The linkage length now has to be adjusted, so
that the landing aps are fully retracted in this
position.
Hook-in position of the landing ap linkage:
Rudder - outermost
Servo - second hole from outside
6